亚洲人成免费网站_国产一区二区三区内射高清_亚洲a在线视频_国产一级色片_a级片观看_在线免费成人网

Company News

當前位置:首頁 >>Company News

Regulating valve flow characteristics selection

發布時間:2018-11-13 關注次數:

Regulating valve flow characteristics selection

The regulating valve is mainly divided into two categories: electric regulating valve and pneumatic regulating valve. The flow characteristic of the regulating valve refers to the relationship between the relative flow rate of the medium flowing through the regulating valve and its opening degree under the regulation that the pressure difference at both ends of the valve is kept constant.

The flow characteristics of the regulating valve are linear, equal percentage and parabolic. The significance of the three fluence characteristics is as follows:

1. Percentage characteristic (logarithm): The relative stroke of the equal percentage characteristic is not linear with the relative flow. The change of the flow caused by the change of the unit stroke at each point of the stroke is proportional to the flow at this point, and the partial ratio of the flow change It is equal. Therefore, its advantage is that the flow rate is small, the flow change is small, and when the flow rate is large, the flow rate changes greatly, that is, the same adjustment precision is obtained at different opening degrees.

2. Linearity (linear): The relative stroke of the linear characteristic is linear with respect to the relative flow. The change in flow caused by changes in unit stroke is constant. When the flow rate is large, the relative value of the flow changes little, and when the flow rate is small, the relative value of the flow changes greatly.

3. Parabolic characteristics: The flow rate varies proportionally to the two sides of the stroke, and generally has an intermediate characteristic of linear and equal percentage characteristics.



Electric control valve daily small problem

When the servo amplifier of the electric control valve is in normal working condition, there may be the following three situations:

(1) When there is no input signal, there should be no output voltage.

(2) Open loop dead zone current ≤ 160μA (type II is 100μA).

(3) When the input signal is >240μA (type II is 150μA), the output load voltage is 205~220V?AC.

(4) The output voltage is basically symmetrical.


微信公眾號
手機網站

主站蜘蛛池模板: 台安县| 海城市| 绥滨县| 长顺县| 襄樊市| 乌鲁木齐县| 留坝县| 华蓥市| 易门县| 社会| 扎赉特旗| 盐边县| 乐业县| 中卫市| 伽师县| 宁武县| 晋江市| 屯门区| 锡林郭勒盟| 高要市| 通榆县| 兴义市| 宜黄县| 渭源县| 乌拉特前旗| 巴林右旗| 米林县| 林甸县| 九龙城区| 福州市| 合肥市| 慈利县| 新巴尔虎左旗| 那坡县| 杭州市| 濮阳市| 海安县| 韶山市| 澄江县| 班戈县| 和林格尔县|